This section describes

JavaView functionality that is available inside the

JavaView application.

# Menu Entries

## Method

### Method > Modelling

#### Close Holes

Closes holes of a surface geometry. Holes need to be bounded by boundary polygons, so if no boundary polygons exist they need to be created first via

Method > Boundary > Make Boundary Polygons.... Adjust the angle such that no corners are detected on the boundary curves and hit OK. Afterwards you can click

**close holes**. This should fill the holes bounded by the boundary polygons with a triangulation.
"close holes" fills all closed boundary polygons, so if there is a boundary component which shall not be closed, it has to have more than one boundary polygon.

((content))

### Method > Effect

#### Minimize

This workshop allows to minimize some energies (e.g. the surface area) by gradient descent. The behaviour of the minimization at the boundary depends on the existence of boundary polygons, which can be created by the workshop

Method > Boundary > Make Boundary Polygons.... If Boundaray polygons exist, the inner vertices of boundary polygons can move according to Boundary constraints - Selected Vertices are always held fix.

### Method > Boundary

#### Make Boundary Polygons...

Extracts the boundary of a surface geometry as polygonal curves. Boundary Polygons are split at selected vertices, which are by default computed from the angle - selections can be changed by the angle slider or by any other way of selecting / unselecting (also by using the "m" and "u" key and klicking the vertices). If the "Make Boundray Constraints" Checkbox is checked, the workshop will test each boundary segment for straightness and planarity and set Boundary Constraints accordingly.
Boundary polygons are not visible (if in the Material Panel "Boundary" is checked, this chows not the Boundary
Polygon information, but all edges where there is no neighbourhood information), the only way to inspect the
Boundary Polygon information is by Method->Info->Print Boundaries - here the number of boundary polygons and
their indices and constraints are printed to the

JavaView console.

((content))

## Comments